Home » How to setup a network on Windows Vista


How to setup a network on Windows Vista

Submitted by dalehunter on Fri, 03/21/2008 - 20:48.
Your rating: None

If you would like to create your own peer-to-peer network at home or in your office, Windows Vista has a wizard that takes you through the necessary steps. You get started by doing the following:

In the Network Center task pane, click Set Up a Connection or Network, click Set Up a Network, and click Next.

 

 

In the initial Set Up a Network wizard dialog box that appears, click Next. The wizard then detects your networking hardware, including whether your network configuration includes a router. Vista can detect whether your network is configured with a router.

Click Configure This Device Manually to open the router's home page (usually found at ip address 192.168.1.1 or 192.168.0.1). If your router supports automatic configuration via a USB Flash drive, click Configure Wireless Settings for My Router and Save to USB Flash Drive instead. You then enter a name for the new network (this doubles as your network's SSID and profile name), enter a WPA security key, and turn file and printer sharing on or off.

Then Vista gives you the choice of saving the network settings to a USB Flash drive. After the settings have been saved, you simply plug the Flash drive into another Vista or XP computer that you want on your network. In the AutoPlay dialog box that appears, you choose the wireless network Setup Wizard option. This runs the wizard and, by using the settings stored on the Flash drive, sets up the computer on the network in seconds. Vista gives you the option of saving the new network settings to a USB Flash drive so you can apply them on other computers that you want on the same network. When you insert the Flash drive in another computer, the AutoPlay dialog box prompts you to start the Wireless Network Setup Wizard.